Ram 3.0L AMDP calibrations built in-house for the Gen 1 EcoDiesel, delivered over the air through the EZ Lynk Auto Agent. This product is for the truck only and not the Jeep vehicle.
The factory 240 hp figure is a OEM decision, not a hardware limit. The OE file is written with margin for the entire fleet. It has conservative fueling, restrained boost targets, and a pedal map that makes the truck feel lazy and slow. AMDP is here to fix that.
Level 1 — Stock Power (+0 HP)
Factory power retained with emissions removed. Pedal mapping linearized and turbo control revised for quicker response. For those daily driving owners towing loads. Typically returns better highway mileage and feeling through the rpm range without increasing component stress in the engine.
Level 2 — Performance (+30 HP)
Level 1 plus increased fueling and turbo control tuned to bring boost in earlier and sustain it through the mid-range. Response is improved, HP and Torque is increased through the entire operating range. Not recommended for heavy towing.
Level 3 — Maximum Effort (+60 HP)
Fueling, timing, and boost optimized to the practical ceiling of the stock hardware. Retains a nice linear power delivery that makes every drive better. For the owners who are always in a hurry. Not recommended for towing.
Note the instructions as they require a little different process than standard EZlynk trucks
Ram Eco-Diesel EZ Flashing Instructions:
1. Connect AA3 to OBDII Port
2. Go to Settings -> WiFi and Connect to AA3 Wifi Network
3. Open AutoAgent App, you should get a notification to auto-lynk
4. Go to Menu (top left) -> ECU Profiles
5. Flash the file labeled "Flash First", when complete key off ignition
6. Disconnect AA3 from OBDII port
7. Reconnect to vehicle and repeat Step 2 and go back to the Auto Agent App
8. Go to Menu (top left) -> ECU Profiles
9. Flash your desired tune
**Note: The "Flash First" file is only required for the initial flash. It is not required to change tune levels down the road.